Publications by    
Page 2 of 2:  Prev << 1 2    (27 Items)
26.  The correlation between x-ray diffraction patterns and strain distribution inside GaInP/GaAs superlattices
X.G. He, M. Erdtmann, R. Williams, S. Kim, and M. Razeghi
Applied Physics Letters 65 (22)-- November 28, 1994
Strong correlation between x‐ray diffraction characteristics and strain distribution inside GaInP/GaAs superlattices has been reported. It is found that the symmetry of (002) diffraction patterns can be used to evaluate the interface strain status. A sample with no interfacial strains has a symmetric (002) diffraction pattern and weak (004) diffraction pattern. It is also demonstrated that strain distribution in superlattices can be readily estimated qualitatively by analyzing x-ray diffraction patterns. reprint
 
27.  Efficiency of photoluminescence and excess carrier confinement in InGaAsP/GaAs structures prepared by metal-organic chemical vapor deposition
J. Diaz, H.J. Yi, M. Erdtmann, X. He, E. Kolev, D. Garbuzov, E. Bigan, and M. Razeghi
Journal of Applied Physics 76 (2)-- July 15, 1994
Special double‐ and separate‐confinement InGaAsP/GaAs heterostructures intended for photoluminescence measurements have been grown by low‐pressure metal‐organic chemical‐vapor deposition. The band gap of the active region quaternary material was close to 1.5 eV, and the waveguide of the separate‐confinement structures was near 1.8 eV. Measurement of the integrated luminescence efficiency at 300 K has shown that over a wide range of excitation level (10–103 W/cm²) radiative transitions are the dominant mechanism for excess carrier recombination in the active region of the structures studied. As determined by spectral measurements, the excess carrier concentration in the waveguide of the separate‐confinement heterostructures and the intensity of the waveguide emission band correspond to a condition of thermal equilibrium of the excess carrier populations in the active region and the waveguide. The ratio of the intensity of the waveguide emission to the active region emission fits a model which assumes that the barrier height for minority carriers (holes) is equal to the difference in band gaps between the active region and the waveguide region. reprint
 
Page 2 of 2:  Prev << 1 2    (27 Items)
Center for Quantum Devices
ECE Department, McCormick School of Engineering, Northwestern University
 Address: Center for Quantum Devices; 2220 Campus Drive RM 4051; Evanston, IL 60208-0893
 Phone: (847) 491-7251
 Email: razeghi@northwestern.edu
© 2020 Center for Quantum Devices, Northwestern University  Disclaimer